Fitness Room Flooring

by DiscoverDuPage

Shop fine solid wood floor fitting room to be effective acceptance – flooring, decoration, inspection – Building Materials Industry

Floor Have a direct impact on the living quality of housing and overall appearance. Therefore, the process of inspection room, the floor is full acceptance Decoration Housing inspection process an important part. Fully furnished room Flooring “Disease” are: Color Played drums, distortion, bias and high and low sound when walking stampede and boring eyes, cracks, scratches, etc. Inspection Division Description: At present, the floor fitting room is fairly conspicuous. Acceptance Solid Wood Flooring First look at the color of the floor are the same. If too much color, directly affect the appearance, may ask exchange; If the color is too consistent, almost no color, it depends on the surface pattern is the same floor. If the pattern has almost the same, then there may be craft wooden floor, not the so-called luxury of wood flooring material. Now, some places Plate Material suppliers, with a general Timber Flooring material, but the surface layer of precious wood affixed to shoddy veneer species, the negative-foil stickers with the good, that is used to moisture, is actually afraid to see the negative and positive patterns are inconsistent. Second floor to see whether there is sound, acceptance on the floor when walking back and forth, step to increase, especially in parts of the wall area and the doorway should be more attention to the inspection, found the site of sound, to repeat the move, to determine the specific location of sounds, well marked. Encountered such a situation, may request the removal of resurfacing. The site has sound, is the process of construction workers in the construction, operation and use of material non-standard unqualified caused. Non-standard operating mainly in places not firmly fixed to the keel; material failed mainly in to the keel without drying. Some decoration construction unit with the land without drying keel construction, the surface has dried traces, in fact, not dry. Specification decorative wood products moisture content should be controlled at about 12%. Keel high ground water, natural drying process in the timber volume will be reduced, resulting in loosening. Once again, whether the acceptance floor deformation, warping, and acceptance is 2 meters long with a ruler, leaning on the floor flatness should not exceed 3 mm. Several multi-pumping measurement, if the passing rate of 80% or more were deemed qualified, the other hand, is unqualified. Sometimes we will find the floor local bagging: If it is solid wood flooring, it is because too tight or the shop floor is too dry (low water content); if Flooring , That is, the poor quality of the floor. Therefore, bagging the floor is a serious quality problems. Final acceptance surface of the floor have boring eyes, cracks, scratches. Common due to the keel of untreated, there are borers. Moth eye is found, the floor has been almost too boring; cracks and scratches to see that. Specification: floor gap should not exceed 0.5 mm; scratches are mainly caused by rough fitting, as with waxing method still can not fix, you must exchange.

Related Fitness Room Articles